Displaying 1 - 10 results of 37 for ""
Published: June 2025
Category:
Road safety hardware and practice
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
This standard drawing shows details of the accepted semi-rigid to rigid barrier transition for use on state highways.
Published: 6 April 2023
Category:
General circulars
,
Technical memoranda
| Audience:
Local & regional government
General circulars are used by NZ Transport Agency Waka Kotahi to directly advise road controlling authorities and regional councils about relevant policy or programme management updates, or to communicate recent Board decisions.
Part of the ‘General circulars’ resource.
Category: General circulars , Technical memoranda | Audience: General
General circulars are used by NZ Transport Agency Waka Kotahi to directly advise road controlling authorities and regional councils about relevant policy or programme management updates, or to communicate recent Board decisions.
Published: 11 June 2009
Category:
Skid resistance & surface texture
,
Technical memoranda
| Audiences:
Road traffic engineers & consultants,
Roading contractors
The 2008 SCRIM survey was an outlier.
Published: 30 April 2014
Category:
Road safety hardware and practice
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
To advise on the recommended practice for the design and installation of a ground beam for the support of semi-rigid road safety barrier systems. This design applies to public domain systems only.
Published: 1 July 2008
Category:
Structures (bridges, culverts & geotechnical)
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
This memo provides details of revisions to Transit New Zealand specification P/24: 2008 and the NZ Transport Agency Endorsed RSMA compliance standard for traffic signs that were implemented on 1 July 2008.
Published: 24 October 2008
Category:
Structures (bridges, culverts & geotechnical)
,
Technical memoranda
| Audiences:
Road traffic engineers & consultants,
Roading contractors
This memo provides details of grates that are acceptable in principle for use with precast concrete headwalls on state highways to protect the headwalls and vehicle occupants from the effects of vehicle impact.
Published: 13 January 2011
Category:
Surfacings & asphalt
,
Technical memoranda
| Audiences:
Road traffic engineers & consultants,
Roading contractors
The procedure for assessing bitumens for acceptance by the penetration test shows the calculations used to set the acceptance limits shown in table 1 of M1 notes:2010.
Published: May 2013
Category:
Road safety hardware and practice
,
Technical memoranda
| Audience:
Road controlling authorities
This technical memorandum provides advice on the recommended practice for the mitigation of hazards associated with tubular handrails commonly installed for pedestrian/cyclist protection adjacent to roadways and on structures.
Published: December 2011
Category:
Road safety hardware and practice
,
Technical memoranda
| Audience:
Road traffic engineers & consultants
To advise on the required practice for installation and maintenance of M19 3 bolt shear base lighting columns to ensure safe operation.
